How to install paint protection film yourself？

In this text, KPAL'll show you the process of PPF installnation,which is a very longand complex procedure and will differ on every car as every panel is different.

Remove the Badge

The reason for removing the Badge is so you can delete the emblem out of the software and you can wrap the film behind it,and you won'持っている カット out line going around it - just leave a clean finish!

Alchhol Wipe

Use alcohol to clean the body completely,and don't let go of the gaps, this is to prevent any clay residue.

Program clip

After the cleaning is finished,we can start toedit the pattern with the cutting film program,and then edit the accessories.You can leave the parts 貴社 必要 in the program and delete the parts you don't need to install.And then cut the stealth ppf off on the plotter - 同時に、it must be ensured その membrane is absolutely clean.

使用方法

Spray much ゲル on the glue layer to ensure that the PPF will not stick tightly to the car paint immediately.

Next lay the film on the part of you want to start, and make sure the edges of the film line up with the car body gap.

Use a scraper to squeeze the gel down from the middle to the edge - this is to ensure that it can be firmly attached to the car body to effectively 守る the car paint.

If there is a deviation in the position, you can gently peel the film back, and continue to spray gel on the glue layer to re-install.

再確認

Check your car multiple times after wrapping the corners- did dirt get in / did you miss a part / did you put the badge back on?

After completing the above steps, you can get a brand new car again!Hopefully,this text will help some installers out there!If you have any questions,you can こちらをクリックto leave an inquiry to KPAL！